CaptMc Posted February 20, 2014 (edited) ]I need help with a modified imperial Flagship i'm working on. How do i attach the bow pieces at the front in LDD. I dont seem to be able to place them where they should be.. This picture should show better which part im on about Edited February 20, 2014 by CaptMc Share this post Link to post Share on other sites
Sebeus I Posted February 20, 2014 I think this connection doesn't work in LDD, it's like fixing a stud in a technic brick, that doesn't work either in LDD. Share this post Link to post Share on other sites
Kolonialbeamter Posted February 21, 2014 Hi there, it's a bit tricky and you'll have to 'cheat' a little, but it's possible. Here's my approach. First you place a regular 1x1 round plate on the one stud, that the SNOT structure is supposed to be based on, place that grey piece on it, and use the hinge tool (in my case -130°). Then place the first row of curved slopes, a connecting plate, remove the grey piece (and the round plate), and mark the following pieces. Make them slide down along that bar, just to place the curved slopes closest to the prefab hull. Last step is to place the rest of the SNOT structure, and clean up. If you feel it necessary, use a bar to connect the structure to the prefab hull. Hope this helps. Regards Share this post Link to post Share on other sites
CaptMc Posted February 21, 2014 Many thanks:) have just tried that and it works :D I'm most grateful to you for helping Share this post Link to post Share on other sites
Kolonialbeamter Posted February 21, 2014 Glad I could help. BTW, this bar-tool-sliding method is also good for a million other things. Brick on! Share this post Link to post Share on other sites