BrickRally217 Posted November 2, 2013 (edited) Hello all! Here are a few pictures of my upgrade to The DeLorean Time Machine set. If you have an upgrade to share, put a picture below so we can all see it! Edited November 5, 2013 by BrickRally217 Share this post Link to post Share on other sites
arc Posted November 2, 2013 I like what you've done with the back, but the front seems a little too long in my opinion. Share this post Link to post Share on other sites
BrickRally217 Posted November 3, 2013 I like what you've done with the back, but the front seems a little too long in my opinion. Yeah you're probably right, but I wanted to use that slope piece for the hood so bad!!! Plus, I wanted to add in that little dark grey strip across the front, so that was the outcome. Share this post Link to post Share on other sites
grymg Posted November 4, 2013 (edited) Here's what I did with the slope piece. Edited November 4, 2013 by grymg Share this post Link to post Share on other sites
badbob001 Posted November 4, 2013 This is my compromise between using tiles and the big boxy slope. Share this post Link to post Share on other sites
AndyC Posted November 4, 2013 Every revision I see with that large slope piece only serves to convince me more that it really doesn't work well at all. Badbob001's solution with the 6x6 tile is pretty cool though, looks like a better trade off. Share this post Link to post Share on other sites
kermit Posted November 4, 2013 I like the back too but the slope piece for the front just seems odd. Share this post Link to post Share on other sites
antp Posted November 5, 2013 Every revision I see with that large slope piece only serves to convince me more that it really doesn't work well at all. Badbob001's solution with the 6x6 tile is pretty cool though, looks like a better trade off. It is still quite long, I prefer the use of three 2x4 (for a 6x4 hood then) Share this post Link to post Share on other sites
BrickRally217 Posted November 5, 2013 Here's what I did with the slope piece. Yeah, that's a good technique. I did something similar to that as a prototype, then took it apart because I thought it looked too boxy and not flat like it should be. But yours turned out well, I like it! This is my compromise between using tiles and the big boxy slope. Oh my gosh! That's a fantastic idea with that BTTF 3 engine piece on the hood. Share this post Link to post Share on other sites
Temet Nosce Posted November 5, 2013 Lots of nice techniques for the slope here, makes it look a lot less blocky! Share this post Link to post Share on other sites