Thirdwigg Posted October 22, 2013 I am looking for an idea for a small trailing caster wheel for my Triple project. Something like this. I hope to have the wheel have a total height of about three studs and mounted to a plate. I have a solution, but it does not pivot. A pivot would be much better. I hope to use this wheel. I would be grateful for any solutions. Share this post Link to post Share on other sites
JTS Posted October 22, 2013 Do we get a share of the prizes for helping? Is that an axlehole going through the centre of the wheel? Share this post Link to post Share on other sites
Thirdwigg Posted October 22, 2013 Do we get a share of the prizes for helping? We can talk if I win. Is that an axlehole going through the centre of the wheel? No, it's a pin hole. @nikolyakov, I was looking for something more Technic-y, but that could work. Also a little more "off-road" would be nice. Share this post Link to post Share on other sites
aol000xw Posted October 22, 2013 If I understood correctly... Those wheels to a plate with pivot are hard, A couple wheels, and a couple attachs to the plate. Share this post Link to post Share on other sites
Thirdwigg Posted October 22, 2013 You understood correctly. That might work the best. I think with a pin stud, it might get the correct height. It does not need to support much weight. Share this post Link to post Share on other sites
nikolyakov Posted October 22, 2013 Steel ball is not in LDD but its exist and fit other part. Last one for off-road fans :) http://www.bricklink...tem.asp?P=bb607 Share this post Link to post Share on other sites
