Lego Otaku Posted April 26, 2012 Based on this MOC: http://www.brickshelf.com/cgi-bin/gallery.cgi?f=151715 I was able to reverse engineer the rings but I wanted mine a little different. Instead of being inside SGC, I wanted it to be outside on stone base and with DHD. The inner ring (750+ pieces): http://www.brickshelf.com/gallery/Lego-0taku/misc/stargate_inner_ring.lxf The outter ring (1500+ pieces): http://www.brickshelf.com/gallery/Lego-0taku/misc/stargate_outter_ring.lxf The DHD: http://www.brickshelf.com/gallery/Lego-0taku/misc/stargate_dhd.lxf I stored the rings separately because it's hard to combine them in free floating situations plus I haven't gotten the ring angle right so the inner ring isn't closed. The parts in the middle are because of collision issue and illegal design: technic pins (3/4, 2L, and longer pins) do NOT go in plate, that causes excess stress and usually ruins the pin after a while. Only the 1/2 pin's stud end can be used safely in plate. Anyway I'd like C&C on the DHD. It'll have printed label to form 2 rings of glyphs with gap between inner glyph ring and the red button. (no round trans-red or trans-orange in 2x2 size??) The DHD should be close to the same scale as the gate itself. I haven't figured out how to do the "wing" part around the side of the DHD. Share this post Link to post Share on other sites
Lego Otaku Posted May 20, 2012 No comment on the DHD? Share this post Link to post Share on other sites
Si-MOCs Posted May 20, 2012 Sorry Otaku, I don't have LDD, so I can't even open your files... So I can't even comment... Maybe post some pictures next time would get people interested and generate some comments? Or perhaps a slightly better phrased title? "Homage to <person>'s stargate" or "My version of <persons>'s stargate" would strike a slightly more positive tone... "stealing" while I understand in jest - may make people pass on the thread ? Share this post Link to post Share on other sites