Iysk Posted May 15, 2011 The ends have this pattern with the sloped curves (two on two of each other clear it out. It's causing me problems as I don't know if parts exist like it to stack onto the top of this to raise it. The one that is blatantly raised above the rest. I don't know how to work around it too well. If it weren't for that, it's be easy to use. Share this post Link to post Share on other sites
Siegfried Posted May 15, 2011 Yeah, it sucks. I had the same problem when I used this hull a few years back. This was my solution... Share this post Link to post Share on other sites
Iysk Posted May 15, 2011 Yeah, it sucks. I had the same problem when I used this hull a few years back. This was my solution... SNIP[/url] How'd you work with the front? Yours is currently better than mine is. Share this post Link to post Share on other sites
Siegfried Posted May 15, 2011 How'd you work with the front? Yours is currently better than mine is. Same method. More pictures are here. (This was my second AFOL MOC so be gentle... ) Share this post Link to post Share on other sites
Iysk Posted May 16, 2011 Same method. More pictures are here. (This was my second AFOL MOC so be gentle... ) It's still better than what I have atm. Woe is me. Share this post Link to post Share on other sites
