Calabar

[KEY TOPIC] Official LEGO Sets made in LDD

Recommended Posts

Aren't there supposed to be a couple of dark silver spheres as ammo for the catapult? The sphere piece in question can be found under the Technic bullet, listed as "ball [diameter symbol]16,5". The diameter symbol is a circle with a diagonal line through it.

I put those behind the castle, right behind where they are supposed to be. If you look in the instructions, they are stored in the castle :wink:

Share this post


Link to post
Share on other sites

For some reason, the arch piece on the front of the ship doesn't fit. I suspect there's some sort of collision with the front of the ship and the arch.

Well spotted, it has been reported to TLG

Share this post


Link to post
Share on other sites

Set: 6266 - Cannon Cove

Theme: Pirate

Side: Imperial Guards

6266_-_cannon_cove.png

All the pieces needed for the model are present in LDD, but I remove the 2 "Bearing element 2x2, Double" (Plate 2x2 with wheels holder) and the 4 "Rim narrow with hole 08" (Wheel centre small), in order to put the cannon inside the cove.

UPDATE: Thanks to Calabar the cannon fully armed is inside the cove...

Also, I forgot to mention that in the original set there is a 8x24 green plate that is absent in LDD, so I use 3 8x8 plates.

The set included a black string, one side tied to the boat and one side tied to the "Lamp Holder" (Plate 1 x 1 with Clip Light - Type 2). Both are present in LDD, but LDD can't tie them, so I remove the string and left the holder in the boat.

Also, the soldier had a brown backpack on top of the Blue "Epaulets". LDD only support one accesorie beside the head, so the backpack was kept and the blue Epaulets removed.

Lastly, in the original design, the "Stick/Aerial" (Antenna 4H) is supposed to be inserted in the "Technic Stick" (Bar 7.6L with Stop) and the Imperial flag put aside,but LDD cannot insert a Stick inside a Technic Stick, so the Stick and the flag where put in the rock.

UPDATE: Again, thanks to Calabar the Stick is on top the Thecnic Stick, not inserted but on top...

Download LXF

Edited by ashir

Share this post


Link to post
Share on other sites

I just realised that my previous two just posted have already been made, but filled under 'town', not 'Pirate'. Sorry everyone! :blush:

Oh porc... azz.gif

Remember to report index errors directly to me, please! Or highlight it in any way.

I could not notice it if simply reported in a sentence inside a post! :classic:

However I recommend to use browser's search in the page to verify if a set has been already made.

So if the set's number is already indexed, you can find it immediately everywhere it is.

@ashir

Usually we prefer to put pieces that we can't insert inside the build aside, and don't remove it from the set.

However, the choice is your.

I tried to fixed your creation, look at it and, if you want, upgrade your file (my file will be automatically removed in few days).

EDIT: re-uploaded the file in its correct version.

Edited by Calabar

Share this post


Link to post
Share on other sites

That was amazing Calabar!

How do you put the fully armed cannon inside the cove, and how you put the stick a top of the thecnic stick?

I reuploaded the LXF...

Set: 6234 - Renegade's Raft

Theme: Pirate

Side: Pirates

6234_-_renegades_raft.png

Fully unmodified set.

Download LXF

Edited by ashir

Share this post


Link to post
Share on other sites

Oh porc... azz.gif

Remember to report index errors directly to me, please! Or highlight it in any way.

I could not notice it if simply reported in a sentence inside a post! :classic:

However I recommend to use browser's search in the page to verify if a set has been already made.

So if the set's number is already indexed, you can find it immediately everywhere it is.

Sorry Calabar, I should've contacted you.

Will search more thoroughly in future!

Share this post


Link to post
Share on other sites

6388 Holiday Home with Caravan

lddscreenshot1.png

LXF File

I just changed the hinged pieces to the new clicky hinge versions. :classic:

Share this post


Link to post
Share on other sites

Updated to LDD 4

6208 - B-wing Fighter - Theme: Star Wars

A pretty easy build overall. The only thing that I couldn't get to work was the 90 degree angle of the hinges for the maintenance stand where the catwalk folds down and meets with each other. They would not go to the full 90. I've left the yellow part of the hinges out (off to the side) of the model.

previewcxs.jpg

Download the .LXF

Edited by messiah1

Share this post


Link to post
Share on other sites

6208 B-wing Fighter

It seems one minifig missing. (6208 on Brickset)

Am I right?

@ashir

"If Mohammad can't go to the mountain, let the mountain come to Mohammad" :tongue:

About the cannon: I placed some plates in the right position so that I could hook the baseplate on the bottom of these plates at the right height related to the cannon. Then I removed additional plates.

In short, I moved the whole set to be in the right place related to the cannon, using a little plate as an hook. (I hope I'm clear...)

About the flag, I put a cylindrical 1x1 brick (with hole) over the technic stick, then I used the brick to place the flag. Finally, I removed the brick.

It is impossible to insert the flag inside the technic pin because the pin is too tight.

Edited by Calabar

Share this post


Link to post
Share on other sites

It seems one minifig missing. (6208 on Brickset)

Am I right?

Oh crap! You're right. I'll update asap. Thanks for pointing it out Calabar.

*Been updated.

Edited by messiah1

Share this post


Link to post
Share on other sites

The largest set I've done so far,

6097 - Night Lord's Castle

lddscreenshot18.png

And you can download it onto LDD here.

Notes: I've had to move a few parts around for it to fit nicely.

EDIT: I also had to make a small work around for those rotating portrait pieces. It doesn't turn, but it looks exactly the same.

Edited by professor flitwick

Share this post


Link to post
Share on other sites

Hey Calabar, are you building the index or you abandon?

BTW, the 6232 in the index is incomplete...

Share this post


Link to post
Share on other sites

@ashir

Usually I update the index in few days.

Under the index, in the same post, you can find all data related to the last update.

So you can check by your own if other models has been added after the last update (usually non more than one or two pages to check).

PS: can't find 6232 in the index. What's the problem exactly?

Share this post


Link to post
Share on other sites

@ashir

PS: can't find 6232 in the index. What's the problem exactly?

Did I said 6232? :tongue: sorry, my mistake, it was 6234. It lacks flag in the pole and shark...

Edited by ashir

Share this post


Link to post
Share on other sites

Tks, tag "incomplete" added.

But I think AndyC will update the file soon, now that someone has noticed it.

Note that there is another 6234 in this topic, post #450, built by Ashir. ;)

EDIT: Oops, Ashir is you! :tongue:

Edited by Calabar

Share this post


Link to post
Share on other sites

Tks, tag "incomplete" added.

But I think AndyC will update the file soon, now that someone has noticed it.

Note that there is another 6234 in this topic, post #450, built by Ashir. ;)

EDIT: Oops, Ashir is you! :tongue:

I know!, that's how I notice it was incomplete... :sadnew:

Share this post


Link to post
Share on other sites

Set: 6513 - Glade Runner

Theme: Town

6513_-_glade_runner.png

Complete set, it only lacks the 3 white stars decoration in the blue plate at front and the minifig face and torso decoration are absent in LDD.

Download LXF

Edited by ashir

Share this post


Link to post
Share on other sites

You linked the (non-existent) file of another set. :wink:

Thanks. I fixed, it will take a couple of minutes to take effect...

Set: 8290-1 - Forklift

Theme: Technic

8290-1_-_forklift.png

Complete and unmodified set!

The only catch is the blue rubber band that can't get attached to the knob in the forklift. LDD limitation... :sceptic:

Download LXF

Edited by ashir

Share this post


Link to post
Share on other sites

Set: 8290-2 - Dragster

Theme: Technic

8290-2_-_dragster.png

Complete and unmodified set!

The only catch is the blue rubber band that can't get attached to the knob below the dragster. LDD limitation... :sceptic:

Download LXF

Edited by ashir

Share this post


Link to post
Share on other sites

Index Updated.

As usual, check your creations.

@professor flitwick

You linked the image instead than the lxf file. :classic:

Edited by Calabar

Share this post


Link to post
Share on other sites

7261-1 Clone Turbo Tank (LUL) (LDD 4.3.5 - Star Wars: Episode 3)

LXF File

clone_turbo_tank_01_2.png

ERRORS:

Replaced parts 48431pb01 with 4524 and LUL assembly with brick-built solution

Incorrect/missing prints

7261-2 Clone Turbo Tank (LDD 4.3.5 - Star Wars: Episode 3)

LXF File

clone_turbo_tank_02_2.png

ERRORS:

Replaced part 48431pb01 with 4524

Incorrect/missing prints

7671 AT-AP Walker (LDD 4.3.5 - Star Wars: Episode 3)

LXF File

atap_walker3.png

ERRORS:

Incorrect/missing prints

7250 Clone Scout Walker (LDD 4.3.5 - Star Wars: Episode 3)

LXF File

clone_scout_walker2.png

ERRORS:

Incorrect/missing prints

Edited by ADHO15

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.