mikey777 Posted July 27 When i draw a brick,plate,tile. it turns into a horrid square. Anyways. Give me a solution! Share this post Link to post Share on other sites
Murdoch17 Posted July 27 @mikey777 If this is in Stud.io, I would suggest asking over on Bricklink's Studio forum, as it's their program and might be a known issue. You'll get a much quicker response on Bricklink as well. Share this post Link to post Share on other sites
JopieK Posted July 27 4 hours ago, Murdoch17 said: @mikey777 If this is in Stud.io, I would suggest asking over on Bricklink's Studio forum, as it's their program and might be a known issue. You'll get a much quicker response on Bricklink as well. One can barely see it, but he is in parts designer. @mikey777 don't go into part designer unless you want to design custom parts, just stay in the main mode... Share this post Link to post Share on other sites
mikey777 Posted July 28 6 hours ago, JopieK said: One can barely see it, but he is in parts designer. @mikey777 don't go into part designer unless you want to design custom parts, just stay in the main mode... what main mode? Share this post Link to post Share on other sites
JopieK Posted July 28 Part Designer is a different tool, you should Studio unless you want to make new/custom parts. Share this post Link to post Share on other sites
mikey777 Posted July 29 17 hours ago, JopieK said: Part Designer is a different tool, you should Studio unless you want to make new/custom parts. i want to make custom parts without the parts being disgusting 2d squares. Share this post Link to post Share on other sites
JopieK Posted July 29 Aha, but that was a little difficult to get from you initial post. Also the topic name does not give any clue of course. Share this post Link to post Share on other sites
