[MOC] Goblin Slayer & Priestess

[Gray Gear]

I finally completed this Figure of Goblin Slayer & Priestess form the Goblin Slayer Manga/Anime Series.

Obviously I used some alternative bricks that are not offered by LEGO, but there is no way I am building armor in anything but flat silver.

The figure itself has been completed for a few months now, but I couldn't find anyone who would print on a 10x10 dish for the shield, so in the end I had to do it myself with spraypaint. This caused me problems since I had never spraypainted anything in more than a single color, but after a few tries and a few ruined pieces I got a decent result.

 

The original idea was to make a half-circle base and place the two figures side by side. But as it turned out Goblin Slayer was way too heavy, and a support was needed to keep the figure from tipping over. In the end I placed the 2 figures back and connected them at the back to back so they can support each other. as you can see there is a support running from the Priestess back to her hair, and the Hair is connected to Goblin Slayers belt.

To make both characters visible I placed the whole Base on a turntable so it can be freely rotated. it has little rubber track inserts at the bottom to stand secure. I originally wanted to place a motor inside (not from LEGO, too loud and power hungry) to slowly spin the MOC, but I haven't figured this out as I have no experience the electronics.

Here are two more pictures of the base details:

 

Overall I am quite happy with how this Project turned out, even if there were some unusually big annoyances along the way. I hope you like my MOC :)

Greetings

Gray Gear

 

[MaximB]

Wow! Cool!
The characters are very recognizable! The base with the chopped goblin is also gorgeous!

[the Inventor]

These figure are really nice, I especially like priestess.