[HELP] Compact cable winch design w/ Brick Engine

[Countdown]

Hello Eurobrickers,

I've been a very long time member lurking all the amazing MOCs and designs.

I need your help for designing a really compact cable system (e.g. crane cable winch) that is self-contained using the Brick Engine PF motor or a M-Motor.

After a few tries (ok, a lot of tries) here's what i came out with. Any ideas on how to improve it? Ideally I would like to keep the whole module under 7 studs width. I don't know if I got a brain fart but I can't figure it out.

Bonus fake internet points to whoever can guess what's the MOC.

 

Thanks all,

Countdown

 

 

 

[Jurss]

Is that downgearing necessary (could be for that small motor) ?

[kolbjha]

3 hours ago, Countdown said:

Bonus fake internet points to whoever can guess what's the MOC

Gantry crane? 

[ninoguba]

What motor is that from?

[Jayden]

You could try using a gear next to the winch reel and driving that with the wormgear.