Sign in to follow this  
zinnn

How to connect those two pieces in Studio? (possibly illegal technique?)

Recommended Posts

So I'm building a MOC in Studio and want to fully slide those technic pins inside the 6 x 1 brick from the bottom (image of how far the software allows me to do it should explain it below). Is there a way to do it in Studio? I'm just learning how to use it, so apologies if it's a basic thing to do.

 

N82gtgE.jpg

Edited by zinnn

Share this post


Link to post
Share on other sites

It is an illegal technique for sure.
Inside the brick, the technic pin have not any space to expand. Keeping it compressed the pin will be damaged after some time.

Share this post


Link to post
Share on other sites

You might have to switch to manual control by pressing "T", then drag the arrows to position the piece exactly where you want it. You can switch the grid size to the smallest setting to have finer control over the movement. 

Share this post


Link to post
Share on other sites

Thanks guys. I actually figured out a workaround for the upside down bricks:

j8CF82K.png

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.