spidercircus Posted February 7, 2021 Hi all, I'm trying to finish up a moc where the large solid wheel (54mm) part# 2515 is part of the engine, with a 6x6 dish fitting inside it. It works in stud.io, but when I try to put it together the dish won't fit inside the wheel. Any ideas if I'm just missing something obvious, or if there's a better way to do this? Share this post Link to post Share on other sites
deraven Posted February 7, 2021 (edited) That is odd. I think there's an issue with the parts in Studio or maybe the collision detection. I can confirm that they definitely don't fit IRL, but in the program if i repeatedly try to make them fit together making fine adjustments Collision Detection will sometimes toggle itself off on its own. Then if I turn it back on it appears the parts fit until I fully move them apart, but then I can't put them back again unless CD is turned off. It's odd. Edited February 7, 2021 by deraven Share this post Link to post Share on other sites
