Collector245

Problem With 1x1 Bricks

Recommended Posts

I have recently noticed a problem with 1x1 bricks. They tend to crack and loose clutch power! Even if they have only been used once! Has anybody else experienced this problem or a problem like this? I am curious to know!

Share this post


Link to post
Share on other sites

I have not experienced this problem before. That is because I don't use them too often except for small builds such as minifig scale televisions, electronics, machines or weaponry. Otherwise I use the round ones for doorknobs. 

Share this post


Link to post
Share on other sites

@Collector245 That's understandable. I refuse bricks all the time and some of them end up getting that way. The 4x2s are the ones I use the most. 

Edited by Brandon Pea

Share this post


Link to post
Share on other sites

I haven't experienced them cracking, but they can lose clutch over time. I imagine this is partly down to them only having one point of attachment.

Share this post


Link to post
Share on other sites
17 hours ago, RoddyMac said:

Some colours are more prone to it than others I believe. 

Indeed. Dark red was one of the problem colours. I had a bunch of dark red pieces crack the moment they were used. LEGO is aware of the issue and has since changed the  composition of certain colours including dark red.

Share this post


Link to post
Share on other sites
4 hours ago, Collector245 said:

@MAB You rarely see them crack unless you look. Loosing clutch power is a result of cracking. The bricks you have that loose clutch power may be cracked. 

None of my weaker ones are cracked.

1x1 cheese slopes, on the other hand, all my weak ones are cracked.

Share this post


Link to post
Share on other sites

The sides of the bricks are under strain from the studs they are connected too.  That strain can deform the brick over time thus a lost of clutch power without visible sign of a fracture failure.  Being 1x1, there isn't as much material to resist the forces of the hunky stud.

 

 

Share this post


Link to post
Share on other sites

While it hasn't happened recently, technically the feet of a minifig are similar to a 1x1 antistud.

The figures I have used on the year 2000 Soccer sets won't grip on regular studs anymore after having them on the soccer field stands for a long time.

The legs aren't cracked however.

I assume the studs on this part are slightly bigger then regular studs to keep them from flying off when playing the game.

4142812

 

 

Edited by TeriXeri

Share this post


Link to post
Share on other sites
45 minutes ago, dr_spock said:

The sides of the bricks are under strain from the studs they are connected too.  That strain can deform the brick over time thus a lost of clutch power without visible sign of a fracture failure.  Being 1x1, there isn't as much material to resist the forces of the hunky stud.

That would make sense. 

 

50 minutes ago, MAB said:

None of my weaker ones are cracked.

1x1 cheese slopes, on the other hand, all my weak ones are cracked.

I have also had 1x1 plates crack. I assume that is because if the same reason @dr_spock mentioned.

Share this post


Link to post
Share on other sites
3 hours ago, TeriXeri said:

4142812

 

 

Plus those studs are taller than normal, and the centre piece pushes the legs outwards slightly to help grip the legs.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.