MOC-0631 (Bay 327 with minor adjustments)

[crimson30]

Mostly finished up my MOC-0631 build (I'm thinking of additional lighting in the future):

 

I made the subfloor in stud.io.  If you're interested in those files, just message me.

I changed up the fight area panels a little (they're a little more stable with the top being anchored) and ran the wires for the two lights in the corner to power up the lightsabers instead:

Edited August 16, 2019 by crimson30

[crimson30]

Just some clarification...

I used a kit from brickstuff for most of the lighting.  The exception is that I bought these:

Pre-soldered Micro LEDs (SMD 0603 white) @ Amazon

and these: Cables for the A3 board from Brickstuff

for the sabers.  I borrowed a hand drill to drill through the arm and saber.  Also, there was a problem with light shining through the sabers, so I used black heatshrink to wrap around the inside hole.  Also, I tested it without the resistor and the LEDs burned up; then I tested with the 100 ohm resistor (for each saber) and left it on for about 12 hours without any issues.

Edited August 15, 2019 by crimson30

[Cylo]

Looks really nice! The lighting is done well!

[sandtrooper]

Very nice work!  This is a build I always wanted to do, but don't have room to put it anywhere.

[crimson30]

11 hours ago, Reaper said:

Looks really nice! The lighting is done well!

I really love the chase lighting... here's a video of it:

Bay 327 vid

 

5 hours ago, sandtrooper said:

Very nice work!  This is a build I always wanted to do, but don't have room to put it anywhere.

A friend of mine found a 40" x 40" table for me that fits right in the corner of my basement.

Edited August 16, 2019 by crimson30