Cosmik42 Posted February 2, 2019 (edited) Has anyone in this forum connected to a SBrick+ programmatically to read sensor data? To my surprise, the data is raw voltage from the sensor, making it sensible to battery level, and I can't figure out a relationship between battery level and the data I am getting from the sensors making impossible to properly calibrate it when battery is not fully charged. Help! :D Edited February 2, 2019 by Cosmik42 Share this post Link to post Share on other sites
XGBC Posted February 2, 2019 you could try and do a calibration with the lowest possible battery voltage and then with the highest to work out the relation between the two. XGBC Share this post Link to post Share on other sites