Recommended Posts

While learning LDD, I am facing a problem. I used Hinge Align Tool to fit a Bean with my model which I added successfully. But it resulted a slight tilt to my whole model with ground, which I do not want. So now one end of model is on ground where other is a bitrHow can I rotate the whole model to rest it completely on ground?

ldd1.jpg

Share this post


Link to post
Share on other sites

You'd just manual-hinge it using a temporary pin on the left. That said, better write down the angles of the working result, and re-hinge it manually because hinge align doesn't work really well.

Share this post


Link to post
Share on other sites

Or put a pin in the lime/green part, and set the angle between the new pin and the build to 0° (or 90°, or ±180°, or −90° depending on what you want).

Share this post


Link to post
Share on other sites

Thanks a lot for the guidance. I just added a PIN to LIME GREEN BEAM, and angled it as instructed, and I could align it with ground.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.