Tomik Posted November 17, 2018 Let me introduce you my latest alternative model - Dune Buggy built out of set 42075 (First Responder). This buggy is my tribute to two special sets: 8829 (my very first LEGO set) and 8048 (the set that definitely ended my dark age). It features front axle steering, rear axle suspension, V2 fake engine and opening cab cage same as original models. I wanted to add differential but it would make engine block too high so it has just "one wheel drive". I hope you will like and any comments are welcome. Share this post Link to post Share on other sites
Nequmodiva Posted November 17, 2018 Nice! Easily the best alternate I've seen from this set. Share this post Link to post Share on other sites
Maaboo the Witch Posted November 17, 2018 This should've been the B-model! Nice. Share this post Link to post Share on other sites
1gor Posted November 18, 2018 Very interesting model but I can not figure out where is differential ? Share this post Link to post Share on other sites
Jurss Posted November 18, 2018 46 minutes ago, I_Igor said: but I can not figure out where is differential 13 hours ago, Tomik said: I wanted to add differential Really good c-model. Share this post Link to post Share on other sites
1gor Posted November 18, 2018 6 hours ago, Jurss said: Really good c-model. Thanks, I didn't wear my glasses Share this post Link to post Share on other sites
Tomik Posted November 18, 2018 Thank you all for your comments. 6 hours ago, I_Igor said: Very interesting model but I can not figure out where is differential ? Differential is in left over parts... Share this post Link to post Share on other sites
Tomik Posted December 2, 2018 Building instructions for this buggy are available at buildinst.cz now. Share this post Link to post Share on other sites
gate Posted December 2, 2018 I would love to see dark gray 1l connectors covering 3l light gray leftover connectors on the cab. May be taken from exhaust pipes, but w/e. Looks really nice. Share this post Link to post Share on other sites
Tomik Posted December 3, 2018 On 12/2/2018 at 1:39 PM, gate said: I would love to see dark gray 1l connectors covering 3l light gray leftover connectors on the cab. May be taken from exhaust pipes, but w/e. Looks really nice. I tried to put them there but I don't like result. It could be good if they were LBG instead of DBG. Share this post Link to post Share on other sites