JasonL Posted February 27, 2018 Hello! Today I have a model of a PRR B6. It's at about 1,000 pieces. The tender has enough room for a battery box and receiver, and an M motor is probably going to go in the wheelbase somewhere. It's also going to have some of Trained Bricks' fancy drive rods eventually, (When it's built) but I need to figure out how to get a valve gear on the thing first. Thoughts and advice appreciated! Revised b6 shunter by Jason_train, on Flickr Revised b6 shunter by Jason_train, on Flickr shunter #5 by Jason_train, on Flickr Revised b6 shunter by Jason_train, on Flickr Share this post Link to post Share on other sites
supertruper1988 Posted February 27, 2018 That looks great! Share this post Link to post Share on other sites
LEGO Train 12 Volts Posted February 27, 2018 I like the side valves Share this post Link to post Share on other sites
Paddi Posted February 28, 2018 Looks nice, would like to se that in real Share this post Link to post Share on other sites