How to use LNP and PF in one program?

By mikezang
May 7, 2014 in LEGO Technic, Mindstorms, Model Team and Scale Modeling

https://www.eurobricks.com/forum/forums/topic/95341-how-to-use-lnp-and-pf-in-one-program/

Followers 2

Recommended Posts

mikezang

Posted May 7, 2014

I use lnp_addressing_printf to show message on PC by lnphost and debug my brickOS program in RCX, that is very good.

Then I also use RCX to send PF signal to control PF receer, it is also good without any problems.

Now I want to use LNP to debug PF control program, I found they can't be used together, if PF control is successful then no any LNP message can be shown, in opposite, if LNP message are shown then PF control can't be done.

I also tried semaphore to control using LNP and PF, but the result is not so good.. I am not so good at infrared communication, I want to know if I want to use both LNP and PF protocol in one program, what should I have to pay attention, are there any tips or hints? does anyone help me?