Thirdwigg Posted October 22, 2013 Posted October 22, 2013 I am looking for an idea for a small trailing caster wheel for my Triple project. Something like this. I hope to have the wheel have a total height of about three studs and mounted to a plate. I have a solution, but it does not pivot. A pivot would be much better. I hope to use this wheel. I would be grateful for any solutions. Quote
JTS Posted October 22, 2013 Posted October 22, 2013 Do we get a share of the prizes for helping? Is that an axlehole going through the centre of the wheel? Quote
Thirdwigg Posted October 22, 2013 Author Posted October 22, 2013 Do we get a share of the prizes for helping? We can talk if I win. Is that an axlehole going through the centre of the wheel? No, it's a pin hole. @nikolyakov, I was looking for something more Technic-y, but that could work. Also a little more "off-road" would be nice. Quote
aol000xw Posted October 22, 2013 Posted October 22, 2013 If I understood correctly... Those wheels to a plate with pivot are hard, A couple wheels, and a couple attachs to the plate. Quote
Thirdwigg Posted October 22, 2013 Author Posted October 22, 2013 You understood correctly. That might work the best. I think with a pin stud, it might get the correct height. It does not need to support much weight. Quote
nikolyakov Posted October 22, 2013 Posted October 22, 2013 Steel ball is not in LDD but its exist and fit other part. Last one for off-road fans :) http://www.bricklink...tem.asp?P=bb607 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.