Searching for long rotor blades

[Omikron]

Hello everyone, I'm trying to find a decent thin lego part thay would act as a rotor blade.

The main problem with existing parts - they are either too thick or too short or too wide.

I need a part ~ 15-20 studs long, half stud or less thin and 2-4 studs wide

Edited August 19, 2013 by Omikron

[twoofive]

the rotor blades of the 9396?

[Omikron]

the rotor blades of the 9396?

This is the last resort, a very good part, but a bit too long

[twoofive]

my son has a 7730 rescue helicopter, these blades are about 16 studs long, 3 wide and a plate thick;-)

the new set 60013 has these blades too;-)

[Marcel1980]

You want make it fly for real?

[dhc6twinotter]

One of these maybe?

http://www.bricklink.com/search.asp?colorID=11&itemID=79833

http://www.bricklink.com/search.asp?colorID=77&itemID=106357

[twoofive]

the most above are the ones i mentioned;-)

[Darth Dino]

You want make it fly for real?

Hi

that will never going to happen with real and pure Lego. It is to heavy and with to less power - just naming two of the 20 reasons for that.

Dino

[Marcel1980]

Hi

that will never going to happen with real and pure Lego. It is to heavy and with to less power - just naming two of the 20 reasons for that.

Dino

I know its not possible. I just want to know what omnikron wants...

[Omikron]

Sorry for confusing people.

No, my current creation is not intended to fly. I'm fully aware that Lego parts are heavy and flight is only possible for very small creations. I prefer the big ones.

I want to thank all the repliers, your answers were very helpful, I've never seen Ninjago before.

Soon I will post my new moc

[Blakbird]

Sounds like you just want a 2x16 plate.