Very important Unimog question

[zewy623]

Ok so I'm supposed to be getting mine pretty soon, and I was going to rc it but I'm not sure what motor to use to steer it. Do you think that a m-motor would be enough to steer it if i replace the friction pins with a cross-axle and some beams, or would it need an xl-motor? I already know that it needs xl for drive. And how many degrees do the wheels turn when fully turned?

Any help would be appreciated.

I need to know asap!

Edited December 27, 2011 by zewy623

[bb15080]

Ok so I'm supposed to be getting mine pretty soon, and I was going to rc it but I'm not sure what motor to use to steer it. Do you think that a m-motor would be enough to steer it if i replace the friction pins with a cross-axle and some beams, or would it need an xl-motor? I already know that it needs xl for drive. And how many degrees do the wheels turn when fully turned?

Any help would be appreciated.

I need to know asap!

http://www.eurobricks.com/forum/index.php?showtopic=57543

m-moter is enough for steering

[allanp]

m-motor will be enough with gear reduction. Standard the wheels don't steer very far but you can improve that by removing 4 darg grey pins in the differencial housing.

[bb15080]

I took the liberty of adapting and LDD this design. (LDD file here)

Works quite well...