Anyway to have LDD tell you what bricks it takes out when you reload a

[Taseden]

Ok this is getting very annoying. When I open a certain model it says it removes one brick. Ok I replace the part and save. Upon re-opening it removes it again. Ok I will just leave that part out, the symmetry of the model will tell me what I am missing. Re-open again. It removes another 2 bricks. This are hidden within the model, structural technic pieces. Awesome, this will definitely help me out. Any way for LDD to list what is removed so I know what is gone from the model? Why does it do this when I place a part legally, then for it to change its mind.

Not to mention how this will effect the instructions to actually build the model when it comes time to it.

Edited December 6, 2010 by Taseden

[Calabar]

When the message about removed bricks is shown, LDD creates a file, UnplaceableBricksDump.lxfml

You can find it in LDD user profile directory.

It contains the LDD model coloured in yellow, except for those bricks that causes the removal of other bricks, that results in red colour.

Try to place again these bricks, this could solve your problem (except when the connection you are trying is absolutely illegal).

[Superkalle]

The same question was put here too. You might find some additional tips there.