Custom sticker sheet or decal help needed.

[Maegnus]

For most of my mocs, I have been able to get by using stock sticker sheets from LEGO, or have been able to find what I needed on ebay (including vintage TMNT stickers for my Party Wagon).

I have hit a snag though. What I need is the Ghostbusters II logo for my Ecto-1A model, now otherwise complete.

The image I speak of is the following:

What I need is that image in various sizes ranging between ~0.5" and ~1.5" (the more the merrier) in diameter for me to apply in the four necessary areas (the two side doors, the back hatch door, and the hood).

I have looked all over the net and have no idea who would be my best bet to help me with this. Does anyone have suggestions? Any and all help would be appreciated.

Thanks all!

[Shadows]

The image I speak of is the following:

What I need is that image in various sizes ranging between ~0.5" and ~1.5" (the more the merrier) in diameter for me to apply in the four necessary areas (the two side doors, the back hatch door, and the hood).

How about using that one?

It's a simple trick, you just need a paint program that allows you to select the DPI (dots per inch) of the resulting print. Since that image is 200x200, it's easy math to figure out what DPI it would take to print various sizes.

2.0" = 100 DPI

1.5" = 133 DPI (close enough)

1.25" = 160 DPI

1.0" = 200 DPI

0.5" = 400 DPI

Not only do you get your logo, but you don't technically resize the image, so there is no loss of resolution and the tiny one will look absolutely amazing.

[Millacol88]

Thats a handy trick, IS. I think you can even do that dpi thing on as basic of an image program as MS paint.