hewkii9 Posted August 19, 2008 Posted August 19, 2008 Hi, I'm thinking of embarking on my first custom minifig project - a Cylon from the old Battlestar Galactica, and I had a question regarding a technique I was thinking of using. Can I take one of the new Agents arms [the cyborg one], stick a cut-off portion of a rubber tube in there, and then stick a minifig hand [cut a bit if necessary] in the hole in the center of the tube? Is it possible? Quote
Kakihara Smile Posted August 19, 2008 Posted August 19, 2008 I don't think a minifig hand can fit in the hole of a cut saber. I could be wrong, this isn't my area of specialty but I don't think it would work, sorry :( Quote
hewkii9 Posted August 20, 2008 Author Posted August 20, 2008 I don't think a minifig hand can fit in the hole of a cut saber. I could be wrong, this isn't my area of specialty but I don't think it would work, sorry :( No, not a lightsaber blade, the pneumatic tubing. Couldn't a minifig hand jam in there if filed down a tiny bit? Quote
Norrington Posted August 20, 2008 Posted August 20, 2008 No, not a lightsaber blade, the pneumatic tubing. Couldn't a minifig hand jam in there if filed down a tiny bit? Yes, they fit. However, they make the tube go under stress so it mught break if you take it out and put it back in to often. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.