[MOC] Trophy truck

[measyn]

Hello everyone!

I've converted the original model for both BuWizz 3 and 2 versions.

Redesigned the front and back suspension a bit. Because the L-motor or PF Servo are heavier than the Geekservo, and the BuWizz unit is lighter than the LiPo 3S battery. So the weight balance is roughly 50/50 now.

I can't test it because I don't have the BuWizz 3, and my BuWizz 2 is very old and laggy. It would be great if someone could build it and share some thoughts and impressions.

 

Powered UP

Power Functions

Also check this review in black color:

 

[Aurorasaurus]

You're in luck! I received another Buwizz 3 and 2 motors today, so I'll gladly build this and test it out. I dont have the same tires you have, or the 3d printed frames and bearings, so the performance might not be perfectly representative.

[measyn]

8 hours ago, Aurorasaurus said:

3d printed frames and bearings

I only added them when I switched from 2s to 3s LiPo batteries, and the reason was a melted shaft on the back axle; the other parts were fine.

Simply wash off the dust after every ride, and the plastic parts will perform just as well.

I've redesigned the construction, making it more modular than ever. You can quickly replace every electric part and wash it under water.

[piterx]

dude that's some top quality performance right there! outstanding job!