Angular M Motor - Remove absolute position?

[Divitis]

 

EDIT: Faulty motor, my bad. In theory at least it works as it should.

 

Hello,

I would like to use the angular motor to steer a vehicle, but I find very annoying that, unlike the L motor, it needs to be pleced perfectly 'zeroed out' in the build.

 

While the L motor 'finds the center' by spinning in both directions until it hits a stop on both sides, and then goes back to the relative middle point, the M Angular always goes back to its 0 mark.

 

Which means, that if your rack and pinion steering 'skipped a tooth' due to a crash or some thinkering, the App calibration doesn't work, and one has to re-align the motor manually, which can be a pain if it's buried inside the model.

 

Is there any way to make the M angular behave as the regular L?

 

Thanks!

Edited January 10, 2024 by Divitis