Is this possible in LDD? (1x3 plate on 4x4 round plate, turned 45 deg)

[LegoJalex]

I want a 1x3 plate to sit on the underside of a 4x4 round plate, but turned 45 degrees. See photo below. When I try it in reality it works, but now when I'm about to make the instructions in LDD I can't get it to work. Is it possible to do? If not, are there any other tricks that can achieve this?

(just saw that the headline was cut after I posted this. "turned 45 degrees" it is supposed to read.)

[Superkalle]

Fixed title for you as best as I could

As for answer, Yes, it's fairly easy to do.

1. put a 1x1 plate in the position closest to the 4x4 hole
   
2. Rotate it 45 degrees.
   
3. Put a 1x3 on top . It will now be in position as you want, just one plate too high up.
   
4. Remove the 1x1 plate under
   
5. Take a new 1x3 and put it in between the 1x1 and 4x4. It will orient itself after the 1x1
   
6. Remove the top 1x3
   

[LegoJalex]

I already got a great solution by Andreas from the Swedish LUG.

Edited September 3, 2016 by LegoJalex

[LegoJalex]

Fixed title for you as best as I could

As for answer, Yes, it's fairly easy to do.

1. put a 1x1 plate in the position closest to the 4x4 hole
   
2. Rotate it 45 degrees.
   
3. Put a 1x3 on top . It will now be in position as you want, just one plate too high up.
   
4. Remove the 1x1 plate under
   
5. Take a new 1x3 and put it in between the 1x1 and 4x4. It will orient itself after the 1x1
   
6. Remove the top 1x3
   

Thanks! I just saw your reply. That is an even simplier solution.