[MOC] Skycrane

[higgins91]

Hello all,

I present you my skycrane made for the 29th Techlug contest

I tried to make a simple and playable moc

the competition is based on a moc manual that must be powered by a M motor and a technic BB.

the cabin is largely glazed permetre for pilots to see outside:

In the center are the gearbox, winch, both engines (dummy: D) and the rotor. A landing gear with suspension occurs from each side.

At the rear the tail and the tail rotor.

At the clip, I looked for a system that allows a quick setting of the container and above a simple and quick release. The principle is a clamps formed of two Liftarm 2 x 4 L-Shape connected by a Axle Connector (Smooth with x Hole + Orientation) that are kept closed by an elastic.

The hook formed by a Axle 3 with stud enters the system by removing the clamp and gets stuck. Then slightly lift the container.

To release, simply remove the clip by both Liftarm 1 x 2 Thin. Simple but effective

it is possible to raise the helicopter by the tail or even by the cab

Placing the engine: under the roof of the cab, it is guided through an opening of 3x3

The BB

result:

And a short vidéo:

Thanks for reading me ;)

[Imanol BB]

Nice work, all the functions work very well and i think you made a very robust and strong body, the suspended wheels and the hooking system are very great details.

[higgins91]

thanks ;)