Mindstorms - Put a wire from a sensor to the nxt brick

[legosubmarine]

Hi !

I'm looking for the way to put a wire from a sensor to the nxt brick, and I didn't find any explanation anywhere.

LDD is a 3D tool, but I really don't get how to put a piece "higher" ("z axis") ??

Could you help me ?

Thanks a lot !

LS.

[Alasdair Ryan]

Hello and welcome to Eurobricks.

In LDD you can only add the ''ends of the cables'' If you require software that will join the two ends together by adding cable you will need to use different software.

The main program that will do what your looking for is called LSynth and works with MLcad.

It can be quite tricky to get the hang off at the start but it will get easer to use.

Edited February 26, 2013 by Alasdair Ryan

[legosubmarine]

Thanks for your answer ! :)

Is there any way to move pieces up and down, following the z axis ?

Thanks !

[dvsntt]

Place bricks Ina stack. Put your piece on top, then remove the stack. Kind of hokey, but that is how I do it.

[legosubmarine]

Thanks for this answer !

[Superkalle]

OT: Is that Galois in your Avatar?