MOC: Valve Gear Fun
Posted 02 March 2012 - 08:25 AM
Texas State Railroad Engine #500 by SavaTheAggie, on Flickr
Now while I'm not willing to go as far down the path of customization that Carl does, I found a lot of inspiration in his design. So I sat down and began playing with my Pacific #500:
#500 Valve Gear by SavaTheAggie, on Flickr
Here's a video:
While it uses the same basic design as Carl's, because my pistons are oriented perfectly vertical, and Carl has more room to work with because he isn't using thin liftarms as connecting rods, the L-Bar looks very strange on my locomotive. It's too far down the length of the locomotive, and far too high above the drivers. The real valve gear, at least on this locomotive, should be centered on the axles.
So I decided to spend some more time with the design, to see if I couldn't get it to sit lower and more closely mimic the motion of the valve gear. Here's what I came up with:
#500 Valve Gear Take 2 by SavaTheAggie, on Flickr
I'm much happier with this design. It isn't perfect, but I think it does the job very admirably. Eventually I'd like to add valve gear like this to all of my TSRR steam roster, and maybe to a few others as well.
And just for the sake of being complete, here's a nice video of the real #500:
And here's another:
SRW Locomotive Works
Posted 03 March 2012 - 01:28 AM
The content of the above post is Copyleft 2012, Hikaro Takayama, all wrongs reserved.
"Wot's faster than a warbuggy, more killy than a warbike, and flies through da air like a bird? I got no bleedin' idea, but I'm gonna find out." - Kog da Flymek, pioneer of the Deffkopta
Posted 03 March 2012 - 10:06 PM
I have to be careful, though, about adding such valve gear will-nilly to my MOCs. I was watching some video last night and came to the realization that Texas State Railroad #201 lacks almost any form of external valve gear, it predates it. Whoops!
SRW Locomotive Works
Posted 04 March 2012 - 06:18 PM
I did the full Walschaert's valve gear for my BR Class 9F but had to mod a few parts. I did something similar for my LMS Garratt, thoguh that has to widen it so that the train motors can swivel inside the driving wheels. this meant I also had to raise the expansion links to clear the platforms! Some of the modded parts I could argue TLG should be making anyway, such as the 1x2 "+o" thin liftarm and 1x3 "ooo" thin liftarm. I have asked them for a 40mm pulley like the 24mm one before.
The way I developed since then does it with fewer mods to liftarms to make the valve gear rods and cranks (no cut up 24mm pulleys!), but with modded model team wheels as an improvement from 40-tooth cogs ('cos TLG don't make train wheels big enough, even as blind drivers):
Carl told me about the cut up baseplate technique. 1 baseplate can make quite a few 1x4s for liftarms!
It shows the possibility of doing all 3 cylinders of a Gresley Pacific (such as Flying Scotsman) or maybe a 2-6-2 V2 like Green Arrow. I hope it will form the basis for my future large steam engine sometime.
Posted 04 March 2012 - 07:58 PM
The build a frigate tutorail!
New members please read the guidelines.
If you have any trouble in posting, deeplinking etc, please consult the tutorials, or the help section.
Reply to this topic
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users