Jareth Posted August 1, 2012 Hey there. I recently made a large demon for a Historica Challenge, and I came up with a usefull way to make my large scale figure hold a weapon. I think this would be the best place to share how I did it. Here is his right hand. Notice how the thumb is connected to one of these. http://peeron.com/inv/parts/3839a Here is the sword. Notice that I put one of these, http://peeron.com/inv/parts/4085a in the hilt. By attaching the two pieces, the demon can hold the sword without using his fingers. Have you seen my beach ball? It's about this big. I may have left it over there. Or Perhaps over there. Eveybody Sing! YMCA! Share this post Link to post Share on other sites
DraikNova Posted August 5, 2012 Interesting idea. Nice work. Share this post Link to post Share on other sites
cylex7 Posted August 11, 2012 I LOVE this Demon! the blend of parts is sleek and it makes him look fast and strong at the same time! The teeth and claws are good as well. No complaints on this one! Share this post Link to post Share on other sites
viracocha Posted August 18, 2012 Whoa! I like this demon! Could you show his back and side view? Share this post Link to post Share on other sites
Logan McOwen Posted August 19, 2012 Hold on. Why is this in the Action Figures section? This is a System MOC. Share this post Link to post Share on other sites
TheRedGuy Posted August 20, 2012 Hold on. Why is this in the Action Figures section? This is a System MOC. Just because it is made out of system does not mean it is not a action figure. :L Share this post Link to post Share on other sites