Sign in to follow this  
Followers 0
Buttons

Don't try this at home

5 posts in this topic

I used to occasionally get into these situations when I was younger. In the first example there, it is still possible to bend back the axle connectors and have them snap out of the axles if you pull hard enough.

The worst assemblies I've done though were in an official set, involving this and this in 8448. These are the only pieces I have never managed to separate no matter what I tried, and they have remained stuck together for 9 years now. :tongue:

Share this post


Link to post
Share on other sites

humm .. already did things like that, you just have to push the axle with a long axle, and it'll be fine^^

Share this post


Link to post
Share on other sites

I've done the worst! Old Bionicle head, insert Onua Claw into the back of the mouth then push an axle through.

Share this post


Link to post
Share on other sites

I made the mistake of putting a axle joiner in a 4 x 6 technic brick and pushing 2 stud axles in it. I ended up cutting the joiner with a hack saw to get it out. :blush:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0

  • Recently Browsing   0 members

    No registered users viewing this page.