Sign in to follow this  
LegoJalex

Is this possible in LDD? (1x3 plate on 4x4 round plate, turned 45 deg)

Recommended Posts

I want a 1x3 plate to sit on the underside of a 4x4 round plate, but turned 45 degrees. See photo below. When I try it in reality it works, but now when I'm about to make the instructions in LDD I can't get it to work. Is it possible to do? If not, are there any other tricks that can achieve this?

29312617062_c382dca57b_z.jpg

(just saw that the headline was cut after I posted this. "turned 45 degrees" it is supposed to read.)

Share this post


Link to post
Share on other sites

Fixed title for you as best as I could :classic:

As for answer, Yes, it's fairly easy to do.

  1. put a 1x1 plate in the position closest to the 4x4 hole
  2. Rotate it 45 degrees.
  3. Put a 1x3 on top . It will now be in position as you want, just one plate too high up.
  4. Remove the 1x1 plate under
  5. Take a new 1x3 and put it in between the 1x1 and 4x4. It will orient itself after the 1x1
  6. Remove the top 1x3

post-4755-0-08361700-1472895647_thumb.png

Share this post


Link to post
Share on other sites

Fixed title for you as best as I could :classic:

As for answer, Yes, it's fairly easy to do.

  1. put a 1x1 plate in the position closest to the 4x4 hole
  2. Rotate it 45 degrees.
  3. Put a 1x3 on top . It will now be in position as you want, just one plate too high up.
  4. Remove the 1x1 plate under
  5. Take a new 1x3 and put it in between the 1x1 and 4x4. It will orient itself after the 1x1
  6. Remove the top 1x3

post-4755-0-08361700-1472895647_thumb.png

Thanks! I just saw your reply. That is an even simplier solution.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.